Bias

Bias has several different meanings, most relating to an offset of some sort.

Table of contents

1 Viewpoint
2 Statistics
3 Science
4 Electronics/Electrical Engineering
5 Communes
6 Seven Sages of Greece
7 Textiles
8 Sports

Viewpoint

A bias is a prejudice in a general or specific sense, usually in the sense for having a predilection to one particular view or ideology. One is said to be biased if one is influenced by one's biases. A bias could for example lead one to accept or non-accept the truth of a claim, not because of the strength of the claim itself, but because it does or does not correspond to one's own preconceived ideas.

An example of bias is having an Americo-centric point of view (the point of view of an Americann, in particular one from the US), or similar for another country.

Systematic bias is also possible in news coverage and may be detected through empirical analysis. For an example, see the statistical findings reported in "Reporting a New Delhi Bias? A Content Analysis of AP Wire Stories on the Conflicts in Sri Lanka and Kashmir," by John Hickman and Sarah Bartlett, in Jouvert: A Journal of Post-Colonial Studies, Volume 6, Number 3 (Spring 2002) at http://social.chass.ncsu.edu/jouvert/v613/sri.htm ).

A systematic bias is a bias resulting from some system. For example, a committee on evolution that meets in a Christian church and is primarilly advertised through fliers in Bibles may have a bias towards Christian views of evolution.

Related: Bias (book by Bernard Goldberg)

See also: Neutral.

Statistics

In statistics, the word bias has at least two different senses, one referring to something considered very bad, the other referring to something that is occasionally desirable. See bias (statistics).

Science

In philosophy of science and experiment design, bias refers to psychological factors which affect scientific hypothesis testing. The variants culture bias, cognitive bias, confirmation bias, infrastructure bias, and notation bias are widely recognized.

Electronics/Electrical Engineering

In electrical engineering, the term bias has the following meanings:

A systematic deviation of a value from a reference value.
The amount by which the average of a set of values departs from a reference value.
Electrical, mechanical, magnetic, or other force (field) applied to a device to establish a reference level to operate the device.
In telegraph signaling systems, the development of a positive or negative DC voltage at a point on a line that should remain at a specified reference level, such as zero.

Note: A bias may be applied or produced by (i) the electrical characteristics of the line, (ii) the terminal equipment, and (iii) the signaling scheme.

(Source: from Federal Standard 1037C and from MIL-STD-188)

Most often, bias simply refers to a fixed DC voltage applied to the same point in a circuit as an AC signal, frequently to select the desired operating response of a semiconductor (forward or reverse bias). For example, a bias voltage is applied to a transistor in an electronic amplifier to allow the transistor to operate in a particular region of its transconductance curve.

Bias is also the term used for a high-frequency signal added to the audio signal recorded on magnetic tape. See tape bias.

Bias is used in direct broadcast satellites such as DirecTV and Dish Network, the IRD box actually powers the feedhorn or LNB receiver mounted on the dish arm. This bias is changed from a lower voltage to a higher voltage to select the polarization of the LNB, so that it receives signals that are polarized either clockwise or counterclockwise, thereby allowing it to receive twice as many channels.

This should also mention bias as the term defined here: http://www.dictionary.com/search?q=bias, def 2.

Communes

Bias is the name of several communes in France:

Bias in the Landes département
Bias in the Lot-et-Garonne département